Yes, when equipped with the optional outdoor vent cap and air inlet shield assemblies.
(CB/CW495-2065 Models Only)
The Copper-Fin must use listed Type B double wall vent material and accessories.
Use the National Fuel Gas Code venting tables for double wall vent to properly size
all vent connectors and stacks.
There are many factors which play a role in determining how far the Copper-Fin
can be vented. Please see the proper vent tables for more information on conventional
venting and the Copper-Fin Installation and Service Manual for limitations on the optional
outdoor venting applications.
No. Lochinvar does not supply field conversion kits with any of its products because of the possible dangers that could occur if the conversion was not done properly. Conversions may only be performed by factory authorized personnel.
Yes, the Copper-Fin may be ordered orificed for operation on either Natural gas or LP gas.
The Copper-Fin is wired for 120 volts and must be electrically grounded in accordance with local codes, or in the absence of local codes, with the latest edition of the National Electrical Code ANSI/NFPA.
Yes, the Copper-Fin can operate at 180°F when functioning as a boiler and as a water heater. CAUTION: Water temperatures over 125°F can cause severe scald burns instantly.
A Copper-Fin is equipped with an adjustable immersion thermostat and an adjustable immersion high limit.
Yes, the Copper-Fin comes equipped with a 24V terminal strip located in the electrical junction box. A set of dry switching contacts may be connected across the R1-W1and R2-W2 terminals to remotely turn each stage on and off. Additional safety controls can be wired and should be connected to the X and B contacts on the terminal strip.
No. All models must be installed on a non-combustible floor.
The heat exchanger is covered under warranty for 10 years on boilers and 5 years on water heaters. Please see the actual warranty for more detail.
Yes, the Copper-Fin water heater comes standard with a 150# temperature/pressure relief valve, and the Copper-Fin boiler comes standard with a 50# pressure relief valve.